WASHINGTON — The U.S. Department of Transportation’s Office of Inspector General announced on November 20 that it will audit how the Federal Aviation Administration (FAA) oversees aircraft manufacturers’ quality controls for suppliers in the United States and abroad. Auditors plan to begin work in December.
Manufacturers with FAA production approval must make sure the parts and services they buy from suppliers meet their requirements. The FAA oversees whether manufacturers are carrying out that responsibility. The audit memo says the agency recently changed how it assesses manufacturing risks, introduced a new system for tracking its oversight work and announced plans to revise its risk model for production approval holders.
An FAA spokesperson told Reuters that the agency would cooperate fully with the audit.
In its October 2024 audit of Boeing 737 and 787 production, the inspector general found that the FAA did not use data-driven risk assessments to decide where to focus its audits. It also found that the agency did not require its inspectors to review first article inspections, which check whether a supplier’s production process can make parts to the approved design from the outset. The FAA’s compliance system at the time could not identify potential repeat violations.
The watchdog also cited the National Transportation Safety Board’s final report on Alaska Airlines (AS) Flight 1282. On January 5, 2024, a door plug separated from a Boeing 737-9 (N704AL) shortly after takeoff from Portland International Airport (PDX). Investigators found that Boeing gave factory workers inadequate training, guidance and oversight to follow its parts-removal process. They also found that ineffective FAA oversight allowed recurring problems with that process to persist.
The inspector general plans to work at FAA headquarters and regional offices under project 27A3003A000. The November 20 memo leaves other locations to be determined during the audit and gives no date for findings.